Limstift Creality 4008030067 til build plate (MPN )

Creality Glue Stick 4008030067 for Build Plate is a stick-format adhesive formulated to improve first-layer adhesion on 3D printer build surfaces. Applied directly to the build plate before printing, the glue creates a temporary tack that helps parts adhere during printing and reduces the risk of warping or detachment. The compact, twist-up format simplifies application and storage for hobbyists and small workshops maintaining Creality build plates or compatible surfaces.

Advantages

The glue stick offers an even, dust-free application without liquid runoff, providing consistent adhesion across the print area. Its solid stick design makes it easy to transport and use without spilling. When applied correctly it facilitates reliable first-layer bonding and reduces failed prints caused by poor bed adhesion. The formulation is suitable for repeated use and straightforward to remove after printing with warm water or a scraper on cooled surfaces.

Suitable for

• Improving first-layer adhesion on glass, PEI, and other common 3D printer build plates
• Use in hobbyist and small workshop environments for routine bed preparation
• Reducing warping and edge lifting on PLA, PETG and similar filaments

Key specifications

• Form factor: solid glue stick for direct application
• Application: topical use on build plate surfaces prior to printing
• Compatibility: intended for Creality build plates and other compatible printing surfaces
• Primary purpose: enhance first-layer adhesion and reduce warping

How to use

Ensure the build plate is clean and free of dust, oils or residue. Twist up the glue stick and apply a thin, even layer across the area where the part will be printed, concentrating on the perimeter and first-layer region. Allow a few seconds for the surface to set before starting the print. After printing and once the bed has cooled, remove the part and, if necessary, clean the build plate with warm water and a soft cloth or gently scrape off remaining glue with a suitable tool.

Recommendations

Apply sparingly — a thin layer is usually sufficient. Test a small area or sacrificial print when changing filament types or switching to a new build surface. Store the glue stick upright in a dry place at room temperature and keep the cap on when not in use to prevent drying.