Adapter ACT FA2057 til 4 x Keystone UTP sort

The ACT Adapterplate for 4 x keystone UTP in black provides a compact surface-mount solution for terminating and organizing four keystone UTP jacks. Designed for structured cabling, the adapter plate accepts standard keystone modules and presents them in a clean, low-profile black finish suitable for both residential and light-commercial installations. The unit is made to fit common wall boxes and mounting frames and allows straightforward access to keystone connectors once installed.

Advantages

The adapter plate supports up to four keystone UTP modules in a single faceplate, simplifying cable management and port labeling. Its black finish reduces visible wear and blends with darker interiors, while the standardized keystone openings ensure broad compatibility with a variety of UTP jacks and modules. Installation is intended to be quick, with screw mounting points compatible with typical mounting boxes and cutouts that align with keystone dimensions.

Suitable for

Key specifications

How to use

Install the ACT adapter plate by mounting it to a compatible wall box or surface bracket using the provided screw holes. Snap or insert keystone UTP jacks into the four openings until they click into place, then terminate the cables to the rear of each jack according to the jack manufacturer's wiring scheme. After termination and testing, secure the faceplate to conceal the connections and provide a finished appearance. Ensure network cables are tested for continuity and correct pairing before finalizing the installation.

Recommendations

For best results, use this adapter plate with certified keystone UTP jacks that match the intended network category (Cat5e, Cat6, etc.). Label ports during installation to simplify future maintenance, and avoid over-tightening mounting screws to prevent cracking the plate. Perform cable tests after termination to verify performance and signal integrity.