D-Link 24-Port 2.5G Multi-Gigabit Unmanaged Switch

D-Link DMS-1024 is a 24-port network switch that supports 10/100/1000 Mbps connections and 2.5G speeds on compatible ports. It is intended for wired LAN environments where a mix of standard gigabit and elevated multi-gigabit connections is required. The switch provides centralized connectivity for desktops, servers and wireless access points, enabling higher throughput on selected ports without replacing existing cabling or devices that support standards up to 2.5G.

Advantages

The switch combines a full set of 24 multi-speed ports with support for 2.5G on designated ports to deliver increased performance for bandwidth-sensitive devices. It offers plug-and-play deployment for straightforward installation in small office or edge, and a compact form factor designed to fit into typical rack or desktop deployments. Energy-efficient operation reduces power consumption under lighter loads, while standard switching features ensure traffic is forwarded with low latency and minimal configuration.

Suitable for

• Small office LANs requiring mixed 1G and multi-gigabit connectivity
• Edge deployments connecting access points and servers with higher throughput needs
• Desktop and workstation connectivity where some devices can benefit from 2.5G
• Network expansions that reuse existing Ethernet cabling while adding faster ports

Key specifications

• Number of ports: 24 multi-speed RJ45 ports
• Supported link speeds: 10 Mbps, 100 Mbps, 1 Gbps and 2.5 Gbps on compatible ports
• Auto-negotiation and auto-MDI/MDIX support for each port
• Switching capacity and forwarding rate suitable for 24-port multi-gig deployments
• Form factor: compact desktop or rack-mountable chassis
• Power: internal power supply with energy-efficient features
• Traffic handling: hardware-based switching for low-latency packet forwarding

How to use

Install the switch on a stable surface or mount it in a rack according to site requirements, connect power, and link network devices using standard Ethernet cables. Devices will negotiate the supported link speed automatically; ensure that endpoints and access points support 2.5G if higher speeds are required. Use the switch as a layer-2 device to aggregate desktops, servers and wireless infrastructure; typical setup does not require additional configuration for basic connectivity. Place the switch near the network edge or in a wiring closet to minimize cable runs and latency.

Recommendations

For best performance, connect high-demand devices such as multi-radio access points or NAS units to the ports that support 2.5G. Verify cable quality—Cat5e or better is recommended for multi-gigabit operation—and keep firmware updated if firmware updates are provided by the vendor. Monitor port utilization and distribute high-bandwidth devices across multiple ports to avoid localized congestion.