Fibertransceivermodul BlueOptics TRX100078-BO XFP LC

The BlueOptics TRX100078-BO XFP LC is a fiber optic transceiver module with an XFP interface and LC duplex connector designed for 10 Gigabit applications. It implements the 10GBASE-LR optical specification for single-mode fiber, supporting long-reach links up to approximately 10 km. The module is compact and lightweight (about 20 g) and follows XFP MSA mechanical and electrical standards for interoperability with compatible networking equipment.

Advantages

This XFP transceiver provides 10 Gbps optical transmission over single-mode fiber using 1310 nm optics and an LC duplex connector. It is manufactured to MSA-compatible dimensions and electrical characteristics to ensure physical and protocol-level compatibility with devices that support the XFP form factor. Built with industry-grade optical and electronic components, the module includes digital diagnostic monitoring (DDM/DOM) functionality for real-time monitoring of parameters such as supply voltage, laser bias current, optical output and input power, and temperature. The design emphasizes long operational lifetime and high mean time between failures for reliable service in data center and enterprise environments.

Suitable for

Key specifications

How to use

Install the transceiver into an XFP-compatible port on your switch, router, or storage device according to the host hardware manufacturer's instructions. Use LC duplex single-mode patch cords to connect to the corresponding fiber infrastructure, ensuring correct transmit/receive alignment. Verify that the host device accepts third-party XFP modules or that compatibility mode is enabled if required. If DDM/DOM monitoring is needed, confirm the host supports reading the diagnostic parameters and query those values through the device management interface for link verification and troubleshooting.

Recommendations

Handle the module with ESD precautions and keep dust caps on the LC connector when not connected. For optimum performance, use single-mode fiber and quality LC patch cords, and follow bend-radius and cleanliness best practices. Before deployment, test the module in the target hardware and validate link performance and DDM readings to ensure full interoperability.