Patchkabel helos 205582 RJ-45 stik til stik 7,5 m

helos 205582 is a 7.5 m RJ-45 male-to-male patch cable engineered for reliable Ethernet connections between network devices. It provides a fixed-length, pre-terminated link suitable for linking switches, routers, patch panels and endpoint devices in both home and office local area networks. The cable is intended to deliver a straightforward physical connection where predictable length and plug-and-play compatibility are required.

Advantages

The cable offers a ready-to-use male-to-male RJ-45 connection that eliminates on-site termination work and reduces installation time. Its 7.5 m length balances reach and cable management for typical room-to-room or rack-to-desk runs. The pre-terminated connectors ensure consistent contact quality and simplify replacement or reconfiguration of network layouts.

Suitable for

• Connecting switches and routers within a rack or cabinet
• Linking patch panels to network equipment
• Connecting desktop PCs, printers or IP devices to wall outlets
• Temporary or permanent LAN runs in home and small office environments

Key specifications

• Cable type: RJ-45 patch cable, male-to-male
• Length: 7.5 meters
• Intended use: Ethernet LAN connections between network devices
• Connector type: 8P8C modular RJ-45 plugs on both ends
• Construction: pre-terminated fixed-length cable

How to use

Insert each RJ-45 plug into the corresponding network port until the connector latches. Use the cable to connect network devices such as switches, routers, patch panels or endpoint equipment. Route the cable to avoid sharp bends and mechanical stress; secure with cable ties or management panels when used in racks or structured cabling to maintain signal integrity and physical protection.

Recommendations

For optimal performance, verify that connected devices support the desired Ethernet speed and check cable routing to minimize interference from power lines or large electrical equipment. Replace the cable if connectors become loose or the jacket shows visible damage. When installing in structured cabling, keep bend radius recommendations and separation from electrical cabling in mind.