Z-akse sensorkabel FlashForge 40001615001 til AD4 3D-printer

Replacement Z-axis sensor cable for FlashForge AD4 3D printer, model 40001615001. This cable connects the Z-axis sensor to the printer control system and is intended for maintenance and repair to restore reliable Z-position detection and improve print stability.

Advantages

The FlashForge Z-axis sensor cable 40001615001 is produced to match original connector types and wiring for straightforward replacement. Using a correct spare cable helps reduce printer downtime, maintains accurate homing and layer alignment, and prevents errors caused by damaged or worn wiring.

Suitable for

• Repairing or replacing a damaged Z-axis sensor cable on FlashForge AD4 printers
• Maintenance tasks to restore accurate Z-position sensing and homing
• Technicians servicing FlashForge AD4 units in workshops or production settings

Key specifications

• Brand: FlashForge
• Model / MPN: 40001615001
• Compatible with: FlashForge AD4 3D printer
• Category: 3D printer accessory — sensor cable
• EAN: 6971940406921

How to use

Power off the printer and disconnect it from mains before replacing the cable. Open the printer casing or access panel to reach the Z-axis sensor connector and control board connector. Carefully disconnect the old cable from both ends, noting orientation or connector alignment, and install the replacement 40001615001 cable in the same positions. Ensure all connectors are fully seated and secured, reassemble the printer, reconnect power, and perform a homing and test print to verify Z-axis sensing and layer alignment.

Recommendations

Handle connectors gently to avoid bending pins; use the original cable routing to prevent snagging or interference with moving parts. If you are unsure about disassembly, consult FlashForge documentation or a qualified technician.