Laminator Olympia 4 in 1 sæt A 230 Plus

The Olympia 4 in 1 Set A 230 Plus includes the A 230 Plus laminator, a trimmer, a corner cutter and lamination pouches. The A4-size laminator supports both hot and cold lamination, accepts pouches up to A4, and offers a compact modern design with a 230 mm laminating width and short warm-up time. Built-in jam release, a high-quality heating system and automatic switch-off protect the device during operation.

Advantages

The laminator supports hot and cold modes and provides a maximum lamination width of 230 mm. It reaches operating temperature quickly, delivers a lamination speed of approximately 400 mm/min and has a reliable heating system with automatic shut-off in case of overheating. The set adds practical tools — a trimmer and corner cutter — plus pouches, for ready-to-use document finishing. A jam release mechanism simplifies error recovery.

Suitable for

• Protecting and finishing A4 documents, photos and certificates
• Small office or home-office lamination tasks
• Craft projects and ID cards with corner trimming

Key specifications

• Model: Olympia A 230 Plus (part of 4 in 1 set)
• Maximum laminating width: 230 mm
• Supported pouch size: up to A4
• Modes: Hot and Cold lamination
• Lamination speed: approx. 400 mm/min
• Power consumption: 305 W
• Input voltage / frequency: AC 220–240 V, 50 Hz
• Dimensions (W×D×H): 366 × 146 × 66 mm
• Colour: Black

How to use

Place the laminator on a stable, level surface and connect it to an appropriate AC supply (220–240 V, 50 Hz). Choose hot or cold mode depending on pouch type, allow the device to warm up until ready, then feed the document inside a lamination pouch into the feed slot aligned with the laminating path. Use the trimmer to cut sheets to the correct size before laminating and the corner cutter to round corners after lamination. If a jam occurs, follow the jam release procedure described in the user manual and allow the device to cool if the automatic switch-off has activated.

Recommendations

Use recommended laminating pouches for hot lamination, avoid overloading the feed with multiple sheets, and allow the unit to cool before prolonged storage. Regularly clean the feed path and follow the user manual for safe operation and maintenance.